OVERKILL Command Line — GstarCAD 2027
OVERKILL Command Line
GstarCAD 2027 · Command Reference
Commands > O Command > OVERKILL > Overkill Command Line
Function Description:
This command is used to remove duplicate or overlapping lines, arcs and polylines, as well combine partially overlapping or contiguous objects.
Command Prompts:
Select object:
Current settings: Tolerance\=0.000001, Ignore\=None, Optimize polylines\=YES, Combine partial overlap\=YES, Combine end-to-end\=YES
Enter an option to change [Done(D)/Ignore(I)/tOlerance(O)/optimize Plines(P)/combine parTial overlap(T)/combine Endtoend(E)]:
Select object
Specifies the object to modify.
Done
Overkills the specified objects according to the current settings.
Ignore
Ignores one or more of the following properties during object comparison.
Ignore [None(N)/All(A)/Color(C)/LAyer(LA)/Ltype(L)/LWeight(LW)/plotSTyle(ST)]:
tOlerance
Specifies the numerical precision of object comparison. OVERKILL compares according to this value to determine the object duplication. The smaller the tolerance value, the smaller the error.
Specify tolerance for object comparison precision \<0.000001>:
optimize Plines
Optimize segments within plines [YES(Y)/NO(N)]:
- YES: Enabled by default. When selected, individual line and arc segments within selected polylines are examined. Duplicate vertices and segments are removed.
- NO: Forces OVERKILL to examine polyline segments individually. Polyline segments may be deleted as duplicates of non-polyline objects.
combine parTial overlap
Combine co-linear objects that partially overlap [YES(Y)/NO(N)] \<Y>:
- YES: Overlapping objects area combined into single objects.
- NO: Overlapping objects are not combined.
combine Endtoend
Combine co-linear objects when aligned end to end [YES(Y)/NO(N)]:
- YES: Objects that have common endpoints are combined into single objects.
- NO: Co-linear objects when aligned end to end are not combined.