Skip to Content

CENTERLTYPE System Variable — GstarCAD 2027

3938  kbadmin September 25, 2026  System Variable Reference

CENTERLTYPE System Variable

GstarCAD 2027 ยท System Variables

System Variables > C System Variables > CENTERLTYPE

Function Description:

The CENTERLTYPE system variable is used to specify the linetype used by center marks and centerlines.
Type String
Saved in Drawing
Initial value "CENTER2"

The CENTERLTYPE system variable applies only to the linetype used on the center marks and centerlines created with the CENTERMARK and CENTERLINE commands. This system variable accepts the following values: "." (use current), ByLayer, or any valid linetype.
Not Rated
Secure Code