GstarCAD 2027 · Command Reference
Function Description:
The LOFTPARAM system variable is used to control the shapes for loft solids and surfaces.
| Type | Bitcode |
| Saved in | Drawing |
| Initial value | 7 |
| Range | 0 \~ 15 |
System Variable Value:
1: no twist(minimize the twist between cross sections)
2: align direction(align the start and end directions for each section curves)
4: simplify(generate simple solids and surface, such as cylinder or planes, rather than spline solids or surfaces )
8: close(close the surface or solid between the first and last cross section)
Article ID: 5681
Created: September 26, 2026
Last Updated: September 26, 2026
Author: kbadmin
Online URL: https://www.kb2.gstarcad.com.my/article.php?id=5681